Publicité
Les langues disponibles
Les langues disponibles
EN
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
44
Length of the partial opening travel (PAR) expressed as a
percentage of the total travel.
NOTE: only the leaf relating to the M1 motor opens
Automatic re-closing time from partial opening PAR (0 = off)
Determines the behaviour of the FLASH output
0 = output always active (not flashing) during the opening and
closing manoeuvre
1 = output flashing during the opening and closing
manoeuvre
Determines the pre-flashing modes of the FLASH output
(deactivated if PRE TIME = 0)
0 = pre-flashing before each opening and closing manoeuvre
1 = pre-flashing before each closing manoeuvre
2 = pre-flashing before each opening manoeuvre
Determines the duration of the pre-flashing (0 = off)
Courtesy light configuration
0 = on during the manoeuvre and, at the end of the
manoeuvre, for the
1= on if the gate is not closed for the
with the gate closed.
2 = lit for a
time after each command
(OPEN, CLOSE, PAR, SBS)
Courtesy light switching on time.
NOTE: the courtesy light can also be turned on and off by radio
remote control; if turned on by radio emote control, it can only
be turned off by radio remote control.
Enables the "man present" functionality on the SBS, PAR,
OPEN and CLOSE inputs
WARNING
enabling the function, the operation of the
radio remote controls is inhibited
Determines the operation of the IND/ELEC output
0 = off
1 = gate open indicator active if the gate is not closed
2 = proportional gate open indicator
- Slow flashing during opening
- Fast flashing during closing
- Two flashes + pause if stopped and not closed
3 = electric lock
4 = magnetic lock, output active if the gate is closed.
WARNING
interface the magnetic lock with a relay with
24VDC coil and set ELECT TIME ≠ 0.
Specifies the number of manoeuvres before reporting a
maintenance request.
NOTE: the signalling occurs using the FLASH output; if closed
it flashes continuously
Enables maintenance request reporting
0 = disabled
1 = active
Electric lock activation time or magnetic lock deactivation time.
Water hammer on opening (0 = off).
When closed, it pushes to close before opening; it is used to
facilitate the release of the electric lock
Water hammer on closing (0 = off).
At the end of the closing manoeuvre, the motor is kept active
for the set time; it is used to facilitate the coupling of the
electric lock.
Release on opening and closing limit switches.
0 = no release
10 = maximum release
In the presence of light gates, it reduces the bending of the
leaf.
If active, it provides maximum acceleration upon starting
0 = disabled
1 = active
50
0
100
0
0
900
1
0
1
0
0
2
0
0
20
0
0
2
0
0
900
0
0
1
0
0
4
X1000
10
0
200
0
0
1
2
1
10
0
0
100
100 ms
0
0
100
100 ms
0
0
10
0
0
1
%
s
s
s
cicli
s
Publicité
