Publicité
4.6 - Deactivation of safety devices
EDGE
The control unit involves (default setting) the installation of a safety
edge connected to the STOP/EDGE inputs. In case of missing or
incorrect connection, operation of the automation is inhibited.
In the case of a system in which the installation of a safety edge is
not envisaged, it is possible to disable its use by moving the EDGE
dip switch to the ON position.
ATTENTION !
CONFIRM THE INTENTION TO DEAC-
TIVATE THE SAFETY EDGE BY PRESSING AND HOLDING
THE BUTTONS
and
FLASHING.
PHOTO 2
The control unit involves (default setting) for the installation of one
or more photocells connected to the PH2 input. In case of missing
or incorrect connection, operation of the automation is inhibited. In
the case of a system in which the installation of PH2 is not envis-
aged, it is possible to disable its use by moving the PH2 dip switch
to the ON position.
4.7 - Display during normal operation
When first switched on, the control unit shows a scrolling text on
the display indicating: board model, firmware version and serial
number and as last information MOTOR SETUP to indicate that
it is necessary to select the type of motor to begin configuring the
system. To select the type of motor, scroll the list with the UP
and DOWN
buttons;
MESSAGES
MEANING
The door travel has not been learned; perform the auto-learning procedure
Gate closed, control panel restarted
The gate is opening
The gate is closing
The gate was stopped during the opening manoeuvre
The gate was stopped during the closing manoeuvre
PH1 intervention (photocell 1)
PH2 intervention (photocell 2)
The automation is performing the realignment procedure
Gate open, automatic closing timer not active
The gate is performing a partial opening
The gate is stopped in the partially open position
The gate has reached the open position and automatic re-closing is active; the flashing dash indicates that the
countdown is active. During the last ten seconds, the seconds remaining until reclosing are indicated
The gate has been opened with the PAR command and the automatic re-closing timer from partial opening is ac-
tive; during the last ten seconds, the seconds remaining until re-closing are indicated
Auto-learning procedure blocked due to safety intervention or intentional stop
Auto-learning of leaf 1 opening travel
Auto-learning of leaf 2 opening travel
Auto-learning of leaf 1 closing travel
Auto-learning of leaf 2 closing travel
Personalised learning of the slowdown point during leaf 1 opening
Personalised learning of the slowdown point during leaf 2 opening
Personalised learning of the slowdown point during leaf 1 closing
Personalised learning of the slowdown point during leaf 2 closing
UNTIL THE EDGE LED STOPS
ATTENTION !
CONFIRM THE INTENTION TO DEACTI-
VATE PH2 BY PRESSING AND HOLDING THE
BUTTONS UNTIL THE PH2 LED STOPS FLASHING.
PHOTO 1
The control unit involves (default setting) for the installation of one
or more photocells connected to the PH1 input.
In case of missing or incorrect connection, operation of the auto-
mation is inhibited.
In the case of a system in which the installation of PH1 is not envis-
aged, it is possible to disable its use by moving the PH1 dip switch
to the ON position.
ATTENTION !
CONFIRM THE INTENTION TO DEAC-
TIVATE PH1 BY PRESSING AND HOLDING THE
BUTTONS UNTIL THE PH1 LED STOPS FLASHING.
at the motor concerned, press and hold down the MENU button
until
appears on the display.
WARNING
The ADVANCED PARAMETERS table shows the
correspondence between the motor model and the numbers on the
display. The following table shows the messages displayed during
normal operation of the automation:
EN
and
and
37
Publicité
