Publicité
1.
4. Pull out the choke knob to the second-stage position.
The choke will close and the throttle lever will then be set in the starting position.
5. While holding the saw unit securely on the ground, pull the recoil starter rope vigorously.
6. When engine has ignited but stalls, first push in the choke knob to the first-stage position and
then pull the recoil starter knob again to start the engine.
7. Allow the engine to warm up with the throttle lever pulled slightly.
4.
WARNING - Be sure to perform warming-up with the guide bar and the saw chain mounted.
- Keep clear of the saw chain as it will start rotating upon starting of engine.
- Before you start the engine, make sure the saw chain is not contacting anything.
- Do not start the engine while the chain saw hangs in one hand. The saw chain may touch your
body. This is very dangerous.
Note: When restarting immediately after stopping the engine, set the Choke knob in the
first-stage position (choke open and throttle lever in the starting position).
Once the choke knob has been pulled out, it will not return to the operating position
even if you press down on it with your finger. When you wish to return the choke knob
to the operating position, pull out the throttle lever instead.
4.5.2- Checking the oil supply
WARNING - Make sure to set up the bar and the chain when checking the oil supply.
If not, the rotating parts may be exposed. It is very dangerous.
1. After starting the engine, run the chain at medium speed and see if
chain oil is scattered off as shown in the figure.
2. The chain oil flow can be changed by inserting a screwdriver in the
hole on bottom of the clutch side.
3. Adjust according to your work conditions.
4. The oil tank should become nearly empty by the time fuel is used
up.
Be sure to refill the oil tank every time when refueling the chainsaw.
4.5.3- Adjusting the carburetor
The carburetor on your unit has been factory adjusted, but may
require fine tuning due to a change in operating conditions.
Before adjusting the carburetor, make sure that the provided air/fuel
filters are clean and fresh and the fuel properly mixed.
2.
3.
5.
1.
2.
Publicité
