Publicité
Les langues disponibles
Les langues disponibles
6.-
FITTING THE SWING POSTS.-
Move the
left swing post
main body (1), Fig.7.and inser it. Fix with screws (124)
together with nylon nuts (125) and washers (141) Fig.7
and tighten securely. Perform the same with your right
hand and
right swing post
covers of the swing posts (92) and (94) and the rear
covers (93) and (95) as shown in Fig 8.and screw them
with the screws (126).
7.-
FITTING THE MONITOR POST.-
Place the post (79) and move it near the main body (1)
as shown in Figure 9. Insert the wire from main body
(1) through the slot of the post (79) as shown in Figure
9 and tighten the post with the screws (128).
8.-
FITTING THE FIXED HANDLES.-
Place screws (136) firstly.
Place the
left fixed handle bar
letter L) and insert it into the external part of the man
body (1) Fig.10, taking special acoount to insert wires
handgrip and taking them through the slot where the
monitor will be placed as shown in details figure
Loosen
the screws (136) with the handle (90)
positioned to hold it firmly.
Perform the same asembly with the right hand and the
handlebar (85).
IMPORTANT: It is advisable to retighten these
screws after one month of using the machine.
9.-
FITTING THE MONITOR.-
Attach the bracket (115) on the support plate monitor
(114) with screws (138) and fix the monitor (113) as
shown in detail in Figure 11 with screws (138)
introducing previously the monitor wires by the support
(114).
Bring the monitor (113) to the monitor post (79) and
(111) to the outer tube on the
(112). Then place the frontal
(90) (marked with the
connect the wires. Place the monitor (113) onto the
plate of the monitor post (79), as shown in Fig.11 being
careful not to pinch the cables. Fix the monitor with the
supplied screws (139) Fig.11.
Then place the bottom cover (84) of the monitor as
shown in Figure 12.
LEVELLING.-
Once the unit has been placed into its final position,
make sure that it sits flat on the floor and that it is level.
This can be achieved by screwing the adjustable feet
(49) up or down, as shown in Fig.13.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (7), as shown in
Fig.14, which make it easier to move.
The two wheels at the front of the unit make it easier to
place the unit in to any chosen position by lifting the
rear slightly.
Store your unit in a dry place, preferably not subject to
changes in temperature.
10.
MAINS CONNECTION.-
Insert the jack for the transformer into the connection
hole on the main body (bottom, rear of the machine)
and then plug the transformer (117) into a 230 V main
supply, Fig.14.
Do not hesitate to get touch with the Technical
Assistance Service if you have any queries by phoning
customer services (see last page in manual)
BH RESERVES THE RIGHT TO MODIFY THE
SPECIFICATIONS OF ITS PRODUCTS WITHOUT
PRIOR NOTICE.
14
G818BM
Publicité
