Parkside PAAL 6000 D1 Instructions D'utilisation Et Consignes De Sécurité page 12

3 . Connect the USB plug (type A) of the
USB cable to a suitable USB power
[ 11 ]
adaptor (not included) .
4 . Connect the USB power adaptor (not
included) to a suitable socket-outlet .
5 . The battery charging status is shown
by the charging indicator
Charging indicator
status
1 LED flashes
1 LED lights up,
1 LED flashes
2 LEDs light up,
1 LED flashes
3 LEDs light up,
1 LED flashes
4 LEDs light up
NOTES:
The charging time is approximately
o
3.5 hours when the battery was
drained .
The product has an overcharging
o
protection system . Nevertheless, you
should disconnect the product from
the mains once the charging process
is complete .
6 . Disconnect the USB cable
product to prevent the rechargeable
battery from discharging itself .
12 GB/IE/NI
:
6 ] [
Battery
6 ] [
charging
status
0–25 %
25–50 %
50–75 %
75–100 %
100 %
from the
11 ] [
7 . Close the protective cap
you start to use the product again .
Otherwise water could enter to the
product when it is used outdoors .
˜ Checking the battery capacity
When product is not charged: Press
o
the battery status button
the battery capacity . The green
charging indicator
capacity* of the battery inside the
product .
Green charging
indicator status
[ 6 ]
1 LED lights up
2 LEDs light up
3 LEDs light up
4 LEDs light up
* This is the approximate percentage
of battery capacity but not actual
measurement .
˜ Operation
Turn the adjustable foot/hand grip
o
and fix the product at desired position.
Tighten the screw of the hinge joint
by hand . The adjustable foot/hand
grip can also be turned up by
4 ] [
approximately 180º and be used as a
hand grip .
before
8 ] [
to check
7 ] [
shows the
6 ] [
Battery
capacity
25 %*
50 %*
75 %*
100 %*
4 ] [
3 ] [