Functional Description - Makita M9200 Manuel D'instruction

8. Be sure that there are no cracks or breakage
on the pad before use. Cracks or breakage
may cause a personal injury.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
･
volts
･
amperes
･
hertz
･
alternating current
･
no load speed
･
Class II Construction
･
orbits per minute

FUNCTIONAL DESCRIPTION

WARNING:
Always be sure that the tool is switched off and
•
unplugged
function on the tool. Failure to switch off and
unplug the tool may result in serious personal injury
from accidental start-up.
Switch action
USD205-1
1
013001
CAUTION:
Before plugging in the tool, always check to see
•
that the tool is switched off.
To start the tool, press the "ON ( I )" side of the switch. To
stop the tool, press the "OFF (O)" side of the switch.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing abrasive paper
1
2
013002
Open the paper clamp by raising on the lever to release
from the locking port and then Insert the paper end into
the clamping part, aligning the paper edges even and
parallel with the sides of the base. (Bending the paper
beforehand makes attachment easier). Once the paper is
in place, return the lever to its original position.
Repeat the same process for the other end of the base,
maintaining the proper paper tension.
After inserting the paper, make sure the clamping part hold
it securely. Otherwise the paper will be loose and subject
to slippage, resulting in uneven sanding operation.
4
before adjusting or
1. Switch
1. Clamping part
2. Abrasive paper
3. Lever
3
checking