17 Data output RS 232 and USB
You can print weighing data automatically via the RS 232C interface or manually
pressing the PRINT button via the interface according to the setting in the menu.
This data exchange is asynchronous using ASCII - Code.
The following conditions must be met to provide successful communication between
the weighing balance and the printer.
• Use a suitable cable to connect the display unit to the interface of the printer.
Faultless operation requires an adequate KERN interface cable.
• Communication parameters (baud rate, bits and parity) of display unit and
printer must match.
17.1 Technical data
Baud rate
4800/9600/19200/38400/57600/115200 selectable
Parity
None, paired, unpaired
• Manually after pressing the PRINT key
Transfer modes
• Automatically according to stability display
• Continuously, according to setting
• On request by external device
92
(remote control commands)
AEJ-C/ AEJ-C/AES-C/PLJ-C-BA-e-1513