CAMSO 5500-00-0200 Mode D'emploi

XTRACK 4S / UTV T4S TRANSFER KIT (RS)
P/N 5500-00-0200
Application: REAR XTRACK 4S / UTV T4S TRACK SYSTEM
Please keep this instruction sheet for future reference or parts ordering information.
Kit Contents:
Ref Part description
1-A LH, bracket anti-rotation (RS) UTV 4S
1-B RH, bracket anti-rotation (RS) UTV 4S
2 HCS, M10-1.5X70, 10.9, ZP, DIN931
3 HCS, M12-1.75X50, 10.9, ZP, DIN933
4 HFSCS, M10-1.5X30, 10.9, ZP, TL, DIN 6921
5 Bushing, anti-rotation UTV (RS)
6 Tandem bushing
7 W, 7/16X1.0X0.072, 8, ZP, USS
8 W, 37.4X13X3, ZP, DIN 9021
9 O-ring 26 x 29 x1.5
10 TW, 1X0.625X0.062
** For model years 2010 to 2013, go to section 3. **
1- Removal of existing parts (MY2014 & +)
1.1 Remove stabilizing arm from anti–rotation mounting
bracket by first removing M12 bolt (a) at
stabilizing arm assembly. Next, remove washer (b),
spring (c) and stabilizing rod (d) from anti-rotation
mounting bracket.
5500-00-0200-MAN
1.2 Uninstall anti-rotation mounting brackets (g) by
removing bolts (e), washers (f), and back plate (h).
1.3 Remove dust caps (i) from the Stabilizer assemblies
Qty
and then remove bolts (j), washers (k), tandem
1
bushings (L) and thrust washers (m).
1
2
2
2- Installation of new parts (MY2014 & +)
4
2
2
6
2
2
4
2.1 Install tandem bushing (6), and thrust washers (10)
in the spacer bushing (5). Apply a thin layer of
grease between the components. Next, install the
O-ring (9) in the spacer bushing groove. Apply
grease to the inside of the bushing and on O–ring.
Apply 0.5 to 1 cc of grease all around.
NOTE: Refer to the "Lubrication" section of the
end of
User Manual.