Publicité
Before Installation
Remove packaging
1. Remove all packing materials from the unit.
● Some packaging materials may be hazardous.
● Please keep all packing materials (plastic bags, styrofoam, etc.) away from
children and properly dispose according to local regulations.
2. Make sure the small triangle foam (Fig. 1) is removed with the bottom foam piece.
● If needed, lay the unit down on its side and remove the foam from the bottom
of the unit manually.
3. Check the washer for any damage such as misaligned or bent door, broken or loose
door hinges and latches, or dents.
● If there is any damage, do not operate the machine and contact a local dealer
or qualified service personnel.
Remove transport bolts
WARNING: Before operating this washing machine, all transport bolts
MUST be removed from the back of the unit. Failure to complete the
steps below may result in serious damage to the machine.
1. Loosen all bolts and plastic spacers (including rubber grommets) with spanner
wrench and remove (Fig. 2).
2. Cover the holes with provided transport hole plugs.
Location Requirements
Selecting the proper location for your washer improves performance and minimizes noise and possible washer
movement. This washer can be installed under a custom counter or in a basement, laundry room, closet, or recessed
area. See "Drain system options" on page 7. Companion appliance location requirements should also be considered.
Proper location selection and installation is your responsibility.
Select a location that meets the following requirements:
1. A water heater set to deliver 120°F (49°C) water to the washer.
2. A grounded electrical outlet located within 6 ft (1.8m) of where the power cord is attached to the back of the washer.
3. Hot and cold water faucets located within 4 ft (1.2m)of the hot and cold water inlet valves, and water pressure of 20 -
100 psi (137.9 - 689.6 kPa).
4. A level floor with a maximum slope of 1" (25mm) under entire washer. Installing the washer on soft floor surfaces, such
as carpets or surfaces with foam backing is not recommended.
5. A sturdy and solid floor to support the washer with a total weight (water and load) of 200 lbs (91 kg).
6. Do not operate your washer in temperatures below 32°F (0°C). Some water can remain in the washer and can cause
damage in low temperatures.
7. Avoid placing the appliance in direct sunlight.
8. Ensure the room has sufficient ventilation.
9. Do not place machine on top of its power cord.
Installation clearances
WARNING: This washing maching is for INDOOR USE ONLY.
Do not install the washing machine in wet rooms such as bathrooms or other areas where the unit could
be sprayed or saturated with water.
Avoid placing in rooms with explosive or caustic gases.
1. The location must be large enough to allow the washer door to be fully opened.
2. Additional spacing should be considered for ease of installation and servicing. The door opens more than 90 degrees
and is non-reversible.
3. Additional clearances might be required for walls, doors, and floor mouldings.
4. Additional spacing of 1" (24mm) on all sides of the washer is recommended to reduce noise transfer.
5. Additional spacing of 2 3/4" (70mm) behind the unit.
CCD-0008970 Rev: 10-1-2024
- 5 -
Fig. 1
Fig. 2
Publicité
