Publicité
REFER TO PAGE 2 FOR FIGURES.
OPERATING INSTRUCTIONS
FOR MODELS WITH DETACHABLE PLUGS
(Plugs may vary by model)
UNIVERSAL AC/DC POWER ADAPTER
1. Remove the wall adapter and clipper from the carton.
2. The clipper comes standard with a universal AC voltage wall adapter and
interchangeable plugs (Figures A-E).
3. To attach the desired plug to the wall adapter, align the slots on the plug to the
ribs on the wall adapter and slide into place. The plug will "click" into place when
properly attached. To remove, locate the button marked "push" on the wall
adapter. Press the button and slide the plug from the wall adapter. The plugs for
the various countries all attach and remove using the same method (Figure F).
4. Plug the adapter cord directly into the receptacle on the bottom of the clipper
(Figure G) and then insert the transformer into an AC outlet.
FOR MODELS WITH FIXED PLUG (UK)
The clipper comes standard with a universal AC voltage wall adapter with a UK plug.
Do not attempt to remove the plug from the cord or plug into any outlet other
than a UK outlet.
CHARGING CLIPPER
The AC adapter is intended for use with Andis Model LCL lithium-ion battery with a
rated capacity of 4.5V
Plug the AC adapter into a 100-120V, 50-60 cycle AC outlet, or as noted on the unit.
Plug the adapter cord directly into the receptacle on the bottom of the clipper (Figure G).
The clipper ON/OFF switch must be in the OFF position for the battery to charge. The
green light on the clipper will turn ON when the clipper is charging. When clipper is
fully charged, the green light will turn OFF.
The clipper has not been charged at the factory. Please charge the clipper for
3-5 hours before FIRST use for maximum performance. When battery is fully
charged, clipper can be used for up to 2 hours of continuous run time. After first
use, clipper will fully charge in a minimum of 90 minutes.
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an appliance you
know is working).
2. Make sure ON/OFF switch on the clipper is OFF.
3. Check to make sure adapter cord is plugged firmly into clipper.
4. If failure to charge still exists, return clipper to Andis or an Andis Authorized
Service Station for examination and repair or replacement.
6
1.2A. Remove the clipper and AC adapter from the carton.
Publicité
