Schlage L9000 Serie Instructions D'installation page 7

1
Install inside non-indicator trim.
1a Install inside spring cage and mounting plate.
Use inside spacer with L9460 x XL11-635.
L The spring cage arrow
must point in direction of
lever down rotation.
OR
Spacer
Interior
1b Install inside trim assembly and thru bolts.
L Install the trim with the thumbturn vertical.
1c Proceed with the appropriate steps to install trim on
opposite side. If both trims are installed, proceed to page
11 to complete installation.
Thumb turn
Make sure tabs are
flush with chassis.
1
Install inside indicator.
1a Rotate the indicator module spindle until the sign moves
down and uncovers the arrow markings.
Do not use tools on spindle!
Front
1b Install inside spring cage and mounting plate.
Use inside spacer with L9460 x XL11-635.
L The spring cage arrow
must point in direction of
lever down rotation.
OR
Spacer
Interior
Install flanges and bolts.
1c
These flanges and thru-bolts are not used in dual
indicator installations.
This step applies to inside indicator installations ONLY.
Thumb turn indicator
Back
Make sure tabs are
flush with chassis.
7