Schlage L9000 Serie Instructions D'installation page 3

6
Install mounting posts to indicator module and bottom
backplate of outside escutcheon.
L For outside single indicator installations only; not
applicable for dual indicator installations.
Find your outside and inside trims on the chart below. Follow
instructions to install both the inside and outside trims.
Outside cylinder
Outside cylinder with indicator
Inside cylinder
Inside cylinder with indicator
Inside thumb turn
Inside thumb turn with indicator
Outside privacy
Outside privacy with indicator
Outside coin turn
Outside coin turn with indicator
Once both trims are installed, go to page 11 for final
installation steps.
Install Trims
Trim
1
Install outside non-indicator trim.
1a Install escutcheon assembly.
1b Insert key halfway into the cylinder, and install the
cylinder with cylinder spring as shown.
Page
3
4
5
5
7
7
8
9
9 1c Rotate cylinder clockwise.
10
Make sure tabs are
flush with chassis.
1d Proceed with the appropriate steps to install trim on
opposite side. If both trims are installed, proceed to page
11 to complete installation.
Outside cylinder
3