Publicité
c Press down the clamp on the cou-
pling.
4. Connect the high-pressure hose to
the high-pressure gun.
a Squeeze the clamp together.
b Pull out the clamp.
c Plug in the high-pressure hose.
d Press in the clamp until it clicks in-
to place.
5. Check the secure connections by
pulling on the high-pressure hose.
6. Insert the mains plug into an outlet.
Water supply
For connected loads, see type plate or
chapter Technical data.
Observe the instructions of the water
supply company.
ATTENTION
Damage due to contaminated water
Contaminated water can damage the
pump and accessories.
For protection, KÄRCHER recom-
mends the use of the KÄRCHER water
filter (special accessory, order number
4.730-059).
Connection to the water line
ATTENTION
Hose coupling with aquastop on the
water connection of the device
Damage to the pump
Never use a hose coupling with aquas-
top on the water connection of the de-
vice.
You can use an aquastop coupling on
the tap.
1. Fit the supplied hose connector to
the end of your garden hose.
2. Attach the garden hose to the cou-
pling for the water connection.
3. Connect the garden hose to the wa-
ter line.
4. Open the water tap completely.
ATTENTION
Risk of damage!
Damaging the pump during dry run-
ning.
Switch off the device if it does not build
up pressure within 2 minutes.
Proceed according to the instructions
in chapter Troubleshooting guide.
ATTENTION
Risk of damage!
The pump can get damaged if the de-
vice is misaligned.
English
Operation
9
Publicité
