Philips Avent SCD510/00 Mode D'emploi page 21

Question
Why does the charging time
of the parent unit exceed 8
hours?
The specifi ed operating range
of the baby monitor is 330
meters/1000 feet. Why does
my baby monitor manage a
much smaller distance than
that?
Why is the connection lost
every now and then?
Why are there sound
interruptions?
What happens during a
power failure?
Is my baby monitor secure
from eavesdropping and
interference?
The operating time of the
parent unit is supposed to
be at least 24 hours. Why
is the operating time of my
parent unit shorter?
Why doesn't the battery light
of the parent unit light up
when I start to recharge the
parent unit?
All manuals and user guides at all-guides.com
Answer
The parent unit may be switched on during charging. Switch off the
parent unit during charging.
The specifi ed range is only valid outdoors in open air. Inside your house,
the operating range is limited by the number and type of walls and/or
ceilings in between. Inside the house, the operating range is up to 50
meters/150 feet.
The baby unit and the parent unit are probably close to the outer limits
of the operating range. Try a different location or decrease the distance
between the units. Please note that it takes about 30 seconds each time
before a connection between the units is established.
If the parent unit is suffi ciently charged, it continues to operate during a
power failure, both connected to and disconnected from the adapter. If
there are batteries in the baby unit, it also continues to operate during
a power failure.
The DECT technology of this baby monitor guarantees no interference
from other equipment and no eavesdropping.
When the parent unit has been charged for the fi rst time, the operating
time is less than 24 hours. The rechargeable battery pack only reaches
its full capacity after you have charged and discharged it at least four
times.
The volume of the parent unit may be set too high, which causes the
parent unit to consume a lot of energy. Decrease the volume of the
parent unit
The microphone sensitivity level of the baby unit may be set too high,
which causes the parent unit to consume a lot of energy. Decrease the
microphone sensitivity level with the SENSITIVITY button on the parent
unit.
It may take a few minutes before the battery light of the parent unit
lights up when you charge the parent for the fi rst time or after a long
period of disuse.
ENGLISH
21