ADURO H1 Mode D'emploi page 58

3) Keep the door approx. 1 cm ajar, until the glass is too hot to touch. Then close the door. When there
are distinct, visible flames and the fire has taken hold, close the primary air intake/damper.
The control handle will get warm when the Aduro H1 is being used. Please
use the glove provided when you operate the Aduro H1.
3.3.3 Lighting the fire with pellets
Push the ON/OFF button and the "On lamp" will display a constant green color. The lighting of the fire will
then start automatically and a flame should appear after approx. 6 minutes. Normal use should be achieved
after 15-20 minutes.
At a 90°C smoke temperature the stove changes to the last setting. You can change between 3 steps by
pushing 'Reset Alarm'.
•
Step 3 (100 % operation): 'On lamp' lights green constantly
•
Step 2 (50 % operation): 'On lamp' blinks quickly
•
Step 1 (10 % operation): 'On lamp' blinks slowly
When you want to switch of the pellet burner, push the ON/OFF button.
3.3.4 Lighting the fire with wood and pellets at the same time
Cold stove
Put the dry wood in the combustion chamber- just as if you wanted to start the stove manually as at point
3.3.1 – however, you won't need any firestarters. After this, the fire is started with pellets as in point 3.3.2. It
will be an advantage, if you start with a closed air inlet until a fire is burning in the pellet burner. After this,
you can open the air inlet for easier lighting of the firewood. When the logs have caught fire and the smoke
temperature is about 275 degrees, the pellet supply will stop automatically.
The stove in pellet operation
When the stove is in pellet operation, you can always add firewood – you just have to remember to close the
door within 3 minutes. Open the door carefully and the pellet supply will stop and the ALARM light is red.
Add firewood of the correct quality and respect the MAX Load line. Close the door again. The stove will
continue combustion of pellets. When the logs are burning and the smoke temperature is about 275 degrees,
the pellet supply stops automatically. After this, the stove will change to WOOD BURNING mode.
58