DeVilbiss Healthcare drive InstaFold Guide D'utilisation page 86

INSTRUCTIONS FOR USE
EN
9.7 After Use Instructions
Turn off the power after use of the powerchair. Store the powerchair in a location that cannot be interfered with by
children, meets the storage temperatures listed in section 5 and is free from excess moisture. Clean the powerchair with
a soft cloth and ensure it is dry (see section 10). Do not use chemicals to clean the powerchair. If the seat cover requires
cleaning, remove it to be washed and allow to dry before placing back on the powerchair.
If the powerchair is to be stored for a long period of time, we recommend fully charging and then removing the battery
to prevent battery drain.
10. CLEANING
Warning
Caution
The surface of the powerchair frame has been treated with a protective coating to allow for easy removal of dirt. Use a
damp cloth with a mild soap to clean the frame and then dry thoroughly.
11. MAINTENANCE & SERVICING
Warning
86
INSTAFOLD™ POWERCHAIR
ve route.
• Never use direct contact with water to clean the powerchair.
• This could cause damage to the electrical components and put the user at risk. Only a damp cloth
should be used.
• Always disconnect the InstaFold™ Powerchair from the mains supply prior to cleaning.
• Never use any neat bleach or similar chemicals on the seat or armrests, as this may cause the seat
to dry out and crack.
• PPE must be worn during manual decontamination to prevent the risk of infection.
• Deviating from the specified cleaning instructions could cause a biological hazard, especially in mul-
ti-user environments, and adversely affect the life and efficiency of the product.
• Regular cleaning can help prolong the lifespan of the powerchair.
• Always disconnect the powerchair from the main power supply and remove the battery prior to per-
forming any maintenance procedures (where viable).
• Never attempt to deconstruct the enclosures, re-wire any components or replace internal battery
components. Modification of the powerchair is not allowed without the permission of the manufac-
turer and electrical system components are only to be replaced by authorised service personnel.
• No maintenance or servicing should be conducted while the device is in use – risk of electric shock,
entrapment, loose parts, etc. If not possible due to the occupant's mobility, a risk assessment should
be carried out, and if deemed safe to proceed, care should be taken to avoid contact with the occu-
pant when working on electrical items.
• Failure to carry out the following checks at the stated frequencies could negatively influence the es-