Fig. 6: If you want to bring the combi-unit into the sitting position,
remove the mattress and attach the 5-point belt (11) and the
abdominal support (12). Always secure your child with the 5-point belt.
Close the belt by joining the two buckles (13) at the belt straps (left
and right) and inserting them into the belt buckle (14) until you hear a
click. To open it, simply press the button in the middle of the belt buckle
(14). The straps can be adjusted to the size of your child with the
tensioning system and the height lock. To make it easier to get in, you
can attach the straps to the loops (15) on the left and right. The
bumper bar (12) is attached to the frame on the left and right under
the swivel joint. Position it and close the locks (a). *To make it easier for
your child to get on, open only one lock and swing the bar to the side.
Fig. 7: To swivel the combi-unit to the two different positions, operate
the sliding buttons (16) and move it to the desired position.
ATTENTION: Only swivel the combi-unit without a child! You can use the
combi-unit with or without an additional footplate in the sitting
position.
Fig. 8: Attach the additional foot board (17) by engaging the
telescopic rod in the two slots provided in the frame. At the back of
the footrest you can press the two sliders of the telescopic pole
together, this makes it easier to attach and is necessary to remove the
footrest. Finally, fasten the cover to the footplate with the press studs
(a).
Remove the markings on the frame, they only serve to indicate this
position.
Fig. 9: You can pull an integrated sun visor (18) out of the canopy. For
better ventilation of the combi-unit, you can provide fresh air at the
head end of the canopy and tub by opening the zippers (19). Fold the
open covers upwards. Two magnets at the foot end secure the open
flap in this position. If you do not fully open the zipper of the foot cover,
you can fold it to the side.