Publicité
4. Install a new dust collection bag by
EN
inserting the bag handle into the card
slot.
5. Install back the dust-removal hub cover.
Fig. E-14-Fig. E-18
Note: It is recommended to replace the
dust collection bag every two months. If the
dust collection bag reaches capacity, the
indicator blinks orange.
Replacing the Battery Pack
The vacuum contains a removable
rechargeable lithium-ion battery pack
which has a limited number of recharge
cycles. After extended use, the battery
pack may no longer hold a charge. If this
happens, it means the battery pack has
reached the end of its life cycle and needs
to be replaced.
1. Press down the battery pack release
button and slide the battery pack to the
right, as illustrated, to remove it.
2. Install the new battery pack.
Fig. E-19
Cleaning the Multi-Surface
Brush
1. Turn the lock counterclockwise until it
stops, then remove the roller from the
roller brush.
2. Use scissors to cut off the hairs and
fibers that get stuck on the brush roller.
Wipe the dust from the notch and
transparent cover with a dry cloth or
paper towel. Thoroughly dry before
use.
3. When it is dirty, rinse the brush roller
with clean water until it is clean.
4. Stand the brush roller upright for at
least 24 hours until it is fully dry.
Fig. E-20-Fig. E-23
8
Cleaning the Soft Roller Brush
1. As shown in the picture, press the
brush roller release button to remove
the roller from the slot.
2. Use scissors to cut off the hairs and
fibers that get stuck on the brush roller.
Wipe the dust from the notch and
transparent cover with a dry cloth or
paper towel. Thoroughly dry before
use.
3. When it is dirty, rinse the brush roller
with clean water until it is clean.
4. Stand the brush roller upright for at
least 24 hours until it is fully dry.
Fig. E-24-Fig. E-27
Cleaning the Motorized Mini-
Brush
1. Use a coin as illustrated to rotate the
lock counterclockwise until you hear a
click.
2. After unlocking the motorized mini-brush,
remove the brush roller, then rinse and
clean it.
3. Stand the brush roller upright in a well-
ventilated area for at least 24 hours until
it is fully dry.
4. Once the brush roller is dry, reinstall it
by following the disassembly steps in
reverse.
Fig. E-28-Fig. E-31
Publicité
