Publicité
Troubleshooting
If the vacuum is not working properly, the screen display will show an error message.
Please refer to the troubleshooting table to find your solution.
Error Icon
Status
Blinking orange
Blinking orange
Solid orange
Blinking red
If one of the error codes from E0 to E4 appears on the display screen, please contact the
after-sales service team.
Working Methods
Select from two working methods for the vacuum, which can be selected based on your
own needs.
Method 1: Discontinuous Cleaning Mode
Press and hold the power button to start the appliance, and release the button to stop
immediately.
Fig. D-3
Method 2: Continuous Cleaning Mode (Trigger Switch Lock)
Press the trigger switch lock to switch to Continuous Cleaning Mode, and then briefly
press the power button to keep the vacuum in Continuous Cleaning Mode.
Note:
• Use the trigger switch lock to free your fingers from fatigue caused by holding the
switch.
• Press the trigger switch lock again to quit Continuous Cleaning Mode.
Fig. D-4
Error Message
Check whether the dust cup,
extension rod, multi-surface brush,
Air duct blocked
soft roller brush or motorized mini-
brush is blocked.
Refer to the [Cleaning the Multi-
Surface Brush] section to clean the
Brush roller stuck
debris and hair tangled on the brush
roller.
Filter is expiring
Please replace the filter in time.
High-
Please wait until the motor
temperature
temperature returns normal.
alert
Solutions
EN
5
Publicité
