Power Supply; Ac Operation; Battery Operation - PERFECTPRO ROCKBOX Manuel De L'utilisateur

POWER SUPPLY

AC operation

Before plugging the AC power cord into the AC socket, make sure the voltage
n
is correct and the Battery charger switch is set correctly: ALKALINE OFF when
using no batteries or Alkaline batteries / CHARGE NiHM ON when using NiMH
rechargeable batteries.
If you use Alkaline batteries in the radio and the Battery charger switch is on
n
ALKALINE OFF, the batteries will be disconnected automatically when using AC
power supply.
If you use rechargeable NiMH batteries in the radio and the Battery charger
n
switch is on CHARGE NIMH ON, the NiMH batteries will be charged automatically
when using AC power supply.
Note:
In order to disconnect the unit from the AC mains completely, the AC power cord should
be removed from the mains socket completely. The AC power cord shall remain readily
operable and should not be obstructed during intended use.
In case of malfunction due to electrostatic discharge or fast transient (burst), remove the
power supply and all the batteries then reinstall the batteries and reconnect the power
supply.

Battery operation

1. To open the battery compartment, first turn the battery cover fixtures counter
clockwise to loosen and pull down the battery cover.
2. This unit can be operated with either Alkaline batteries (6 x 1,5V type IEC LR14 /
UM-2 / C-size) or NiMH rechargeable batteries (6 x 1,2V PerfectPro Rechargeable
Accu, C size HR14 / 4000mAh). Set the Battery charger switch in the battery
compartment according to the battery type to be used (ALKALINE OFF or
CHARGE NIMH ON).
3. Insert the batteries with correct polarity as indicated in the battery compartment (+
and -). Close the battery cover and fasten the fixtures by turning clockwise. Close
well to prevent moist or dust from entering the compartment.
4. If the unit is not to be used for an extended period of time, it is recommended that
the batteries are removed from the radio.
The approximate power level of the batteries is displayed in the LCD display of the radio.
When the power level is very low, the indication "Battery Low!" appears and the battery
symbol flashes on the display. The batteries should then be recharged or replaced soon
to continue normal operation of the radio.
When the rechargeable NiMH batteries are being charged. The battery symbol in the
LCD display will animate. The charging and animation will stop automatically when the
batteries are full.
5