Publicité
BASIC OPERATION
FREE AREA
0.6
(2
m
TYPE 1
TYPE 2
ADJUST HEIGHT
LOCK
ADJUSTMENT
46
LOCATION OF THE ELLIPTICAL
Place the elliptical on a level surface. There should be one foot of clearance
in front of the elliptical for the power cord. For ease of access, there should
be an accessible space preferentially on both sides and the rear of the
elliptical that is at least 0.6 meters (24 inches). Do not place the elliptical
in any area that will block any vent or air openings. The elliptical should
not be located in a garage, covered patio, near water or outdoors.
MOVING THE ELLIPTICAL
Your elliptical has a pair of transport wheels built into the front
)
stabilizer tube. To move, first remove the power supply and firmly
ft
grasp the steel portion in the rear of the elliptical, carefully tilt and roll.
Note: be sure to grab the steel bar and not the plastic cover.
WARNING!
Our ellipticals are heavy, use care and additional help if necessary when
moving. Failure to follow these instructions could result in injury.
LEVELING THE ELLIPTICAL
Your elliptical should be level for optimum use. Once you have placed your elliptical
where you intend to use it, raise or lower one or both of the adjustable levelers
located on the bottom of the frame. A carpenter's level is recommended.
There are two types of levelers on our ellipticals:
TYPE 1: Raise or lower one or both of the adjustable levelers located on the
bottom of the frame using a 6mm allen wrench through the access hole.
TYPE 2: Raise or lower one or both of the adjustable levelers located on the bottom
of the frame by rotating the leveler. Once you have leveled your elliptical, lock the
levelers in place by tightening the nuts against the frame.
Publicité
