Publicité
BODYPACK TRANSMITTER
5
4
ON / STANDBY / OFF
1
Switch for switching the pocket transmitter on or off (ON = transmitter switched on, OFF = transmitter
switched off). In the STANDBY position, the transmitter is in operation but the audio signal is muted.
INPUT
2
3-pin mini-XLR jack for connecting a headset or lavalier or instrument microphone and a guitar cable.
MIC / 0dB / -10dB
3
Adjust the input sensitivity. Set the sensitivity so that when a signal is present (speech, vocals, guitar ...)
the AF LED of the receiver lights up green. As soon as the audio signal begins to distort, reduce the
sensitivity by setting the 3-step switch MIC / 0dB / -10dB to the next lower value.
Examples: Headset = MIC, guitar with passive pickup = 0dB, guitar with active pickup = -10dB.
STATUS LED
4
If the charging status of the inserted batteries is sufficient, the LED lights up green when the transmitter
is switched on. If the LED lights up red, the charging status is low. Replace the used batteries immediately.
ANTENNA
5
Antenna of the bodypack transmitter. For optimum reception, do not cover or bend.
IR INTERFACE
6
The infrared interface for synchronising the radio channel of the receiver and transmitter is located in
the battery compartment. To open the battery compartment, press both markings on the sides of the
battery compartment cover at the same time and flip it forward (for synchronisation procedure, see
RECEIVER MODULE – SYNC).
4
2
3
1
5
6
23
Publicité
