Eaton Tripp Lite Serie Mode D'emploi page 16

Command Line Interface
Table 3. CLI Commands
User Command Name
login
logout
set_new_password
set_ipv4_maskaddr
get_ipv4_maskaddr
set_ipv4_addr
get_ipv4_addr
set_ipv4_gateway
get_ipv4_gateway
get_ipv4_method
set_ipv4_method_dhcp
get_mac_addr
get_proxy_addr
set_proxy_addr
get_proxy_port
set_proxy_port
10 Eaton Tripp Lite Series Cloud Connected UPS System User Guide 934927—Rev B
Description Sample Input/Output
login to the shell <password>
logout of the shell N/A
Set a new password
"Pa$sw0rd"
Set the subnet mask 255.255.255.0
address
255.255.255.0
Get the assigned subnet
mask address
Set the assigned IP 192.168.0.133
address
Get the assigned IP 192.168.0.133
address
Set the IP gateway 192.168.0.1
Get the IP gateway 192.168.0.1
Get the IP method IP Method set as static/
DHCP.
Set DHCP IP IP Method set as DHCP
Get MAC Address 00:00:00:00:00:00
Get the assigned proxy PROXY Address is -
address proxy.apac.etn.com
Set the proxy address Proxy address
reconfigured
successfully.
Get the port PROXY port is - 8080
Set the port Proxy port number
reconfigured
successfully.
Note
Only used for entering to shell It gets the
current password as input
This command prompt you to login after logout
The default value is "password". New
Password has following limits:
1. The length must be at least 8 and max 16
characters.
2. The string is alphanumeric case
sensitive.
3. The new password must at least have
one digit, one upper case, one lower
case, and one special case characters.
4. The previous password is required to
enter.
5. The new password must be entered
twice.
This value will initialize as "0.0.0.0" if the
device is not connected to the internet. The
default restore IP address is "192.168.1.254".
The default value is DHCP.
The length must be less than 20 characters
Any range between 0-65535