Publicité
Low liquid level control
The integrated low liquid level control prevents the
appliance from starting when there is no liquid in
the blender jug 5 .
Cleaning and Care
Ideally, you should clean the appliance immediate-
ly after use . Dried food residue is more difficult to
remove .
DANGER –
RISK OF ELECTRICAL SHOCK!
►
Ensure that no moisture can get into/onto the
built-in plug 4 and the safety socket 2 on
the blender jug 5!
►
Ensure that no moisture can get into/onto
the contact plug 1 on the lid on the blender
jug 9!
Never immerse the lid 9 in water or other
liquids! Otherwise there is a risk of an
electric shock .
WARNING! RISK OF INJURY!
►
Take care when cleaning the lid 9 and the
attached blades 6! The blades 6 are
extremely sharp!
1) Add a little warm water and a drop of washing
up liquid to the blender jug 5 .
2) Place the lid 9 on the blender jug 5 . Ensure
that the contact plug 1 in the lid 9 fits cor-
rectly in the safety socket 2 .
3) Insert the connector 3 into the built-in plug 4
on the appliance .
4) Insert the plug into a mains power socket . You
will hear a beep and the programme indicators
flash .
5) Press the MODE button q repeatedly until the
MIXER programme indicator
flash .
6) Press and hold the START/STOP button i and
allow the appliance to run for about 20 seconds .
■
10
│
GB │ IE
7) Remove the power plug from the mains power
8) Remove any stubborn residue in the blender
9) Afterwards, empty the blender jug 5 and
10) Wipe the exterior surfaces of the blender jug 5
11) Wipe the lid 9, blades 6 and sensor 7 with
z starts to
socket .
jug 5 or the blades 6 using a washing up
brush or a washing up sponge .
rinse it out thoroughly with clear water .
with a moist cloth . If required, use a mild wash-
ing-up liquid on the cloth . Afterwards, wipe off
with a cloth moistened only with clear water
to ensure that no detergent remains on the
appliance .
a damp cloth . If required, use a mild wash-
ing-up liquid on the cloth . Afterwards, wipe off
with a cloth moistened only with clear water
to ensure that no detergent remains on the
appliance . Ensure that no moisture can get into
the contact plug 1 on the lid on the blender
jug 9!
Publicité
