Publicité
on the weighing bowl
and no button is pressed, the product will auto-
matically switch off.
Troubleshooting
= Fault
= Cause
= Solution
= The display shows one of the following symbols
when you switch on the product:
• "T"; or
• "-" symbol; or
• the numerical display
= The product has memory features of the previous
weight before switching off the product and affects
the calibration point during activation.
= 1. Remove any load from the weighing surface
if any.
2. Set the product on a solid, level and flat surface.
3. Reset the product by holding the button UNIT
for approx. 3 seconds.
4. The product is re-calibrated and the whole
LC display
2
5. The numerical display
with the default unit.
6. You can place the item you wish to weigh
onto the product.
=
= The product is overloaded.
= 1. Remove the overload.
12 GB/IE/NI
for approx. 3 minutes
1
showing any weight
8
will be shown for 2-3 seconds.
will read "0" again
8
2. Reset the product by holding the button
UNIT
4
3. The product is re-calibrated and the whole
LC display
4. The numerical display
with the default unit.
5. You can place the item you wish to weigh
onto the product.
Note: If
is shown again, it means the overload is
greater than the max. measuring range. Remove the
overload.
Note: Be sure never to add more than 5 kg to the
,
weighing surface
5
damage it.
=
4
= The batteries are too weak to weigh. You cannot
operate the product.
= Replace the battery (see section "Replacing the
battery").
Note: The product contains sensitive electronic compo-
nents. For this reason it is possible that it can be dis-
rupted by radio transmitting equipment in the immediate
vicinity. If the LC display
such objects away from it.
Electrostatic discharges can lead to malfunctions. In
cases of the product failing to work, remove the batter-
ies for a short while and then replace them.
for approx. 3 seconds.
will be shown for 2–3 seconds.
2
will read "0" again
8
. Overloading the product can
5
indicates a problem, move
2
Publicité
