shark SV1106 N Manuel Du Propriétaire page 24

e
4 Inspect the rotating brush for a build-up of debris. Remove
anything wound around the brush by carefully cutting it with
scissors. The brush roll is equipped with a raised cutting
guide to make inserting scissors easier. Avoid damaging or
cutting the bristles. (e)
5 Use a flashlight to inspect inside the air duct at the bottom of
the main body and remove any debris or blockages that may
be there. Reattach the motorized floor nozzle, ensuring it
clicks into place.
6 Remove the dust cup and use the flashlight to check the air
path on the spine of the vacuum and remove any debris or
blockages. Then replace the dust cup.
BRUSH BAR REMOVAL
1 For easier cleaning, the brush roll can be removed from
the nozzle. Using a coin, turn the dial next to the brush roll
access door to the unlock position. (f) Remove the brush roll
access door. (g)
2 Slip the black belt off of the white gear and lift out the brush
roll. (h)
24 1-800-798-7398
h
f
j
i
BRUSH BAR INSERTION
1 To reinsert the brush roll, first slip the black belt onto the
white gear (i), then align the white square on the opposite
side of the brush roll into the square slot. (j)
2 Align the white square on the belt side and position into its
slot. (k)
3 Replace the door, inserting the wheel side first. Use a coin to
move the dial to the lock position.
RESTARTING AFTER A JAM
If the indicator light around the power button flashes, the brush
bar has jammed and will cease to operate.
1 Turn the unit off and allow it to cool down for 10 seconds.
2 Ensure that nothing is blocking the motorized brush or
wrapped around the brush bar.
3 Turn the power on and the unit should operate normally.
g
k