Using The Dj Microphone; Playback On The Computer; Handling - Renkforce SA-101U Mode D'emploi

g) Using the DJ microphone
• Set the input level and the sound of the microphone input MIC (2) as described above under „Volume
control".
• Press the TALKOVER switch (5) to make an announcement.
• The DJ microphone signal is switched to the master output. The volume of the other channels is reduced.
h) Playback on the computer
• Set the input selection switch of CH-3 to USB.
• On the computer, start playback with your audio software.
If necessary, the USB output on the computer has to be configured as an audio output (see the
documentation of your operating system or your audio software).
• The USB interface is treated like a common analogue audio input.

10. Handling

• Never connect the power plug immediately after the device has been taken from a cold to a warm envi-
ronment. The condensation generated could destroy the device.
Allow the device to reach room temperature before connecting it. Wait until the condensation water has
evaporated.
• Never pull on the power cable. Only unplug it by pulling on the plug.
• Unplug the power supply if you do not use the device over a period of time.
• For safety reasons, always pull the mains plug from the socket during a thunderstorm.
• Do not listen to excessively loud music over an extended period of time. This may damage your hearing.
38