Publicité
Step 1
å
Assemble your unit on a carpeted floor or on the empty
carton to avoid scratching your unit or the floor.
å
Fasten the TOP MOLDING (D) to the TOP (C). Use five
BROWN 1-1/2" FLAT HEAD SCREWS (14S).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
www.sauder.com/service
Look for this icon. It means a video assembly tip is
available at www.sauder.com/service/tips
Find the numbered video or scan the QR code.
14S
BROWN 1-1/2" FLAT HEAD SCREW
(5 used in this step)
D
C
433961
0
Just think. The sooner
you do this, the sooner
you do something else.
Angled edge
Page 5
Publicité
