Publicité
Step 32
1
D22
K
Groove
å
Insert the DRAWER SIDES (D22 and D23) at an
angle into the slot at each end of the OUTER
DRAWER FRONT (K).
3
M64
1
M64
Surface with
HIDDEN CAM
å
Push one HIDDEN CAM (1F) into the DRAWER
BRACE (M64). Then, insert the metal end of a CAM
DOWEL (2F) into the HIDDEN CAM.
å
Fasten the DRAWER BRACE (M64) to the OUTER
DRAWER FRONT (K). Tighten one HIDDEN CAM.
www.sauder.com/service
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D23
Arrow
Metal end
1F
2F
Hidden part using
recycled material.
Color may vary.
K
2
D22
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the LARGE DRAWER BOTTOM (D705) into the
grooves in the DRAWER SIDES (D22 and D23) and
OUTER DRAWER FRONT (K).
4
D22
M64
å
Fasten the LARGE DRAWER BACK (D164) to the DRAWER
SIDES (D22 and D23) and DRAWER BRACE (M64). Use
five BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
Repeat this step for the remaining outer drawer.
433961
1
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
D705
U n fi
n i s h
e d
s u r
f a c
e
K
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(10 used in this step)
D164
D23
9
D23
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Page 37
Publicité
