Sauder Credenza Aspen Post Instructions D'assemblage page 10

Step 6
å
Fasten one of the SIDE SKIRTS (N) to the LEFT END (B).
Use four SILVER 1-1/8" FLAT HEAD SCREWS (10S).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
å
Fasten one of the SHORT END MOLDINGS (E) to the LEFT
END (B). Use two SILVER 1-1/8" FLAT HEAD SCREWS (10S).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
SILVER 1-1/8" FLAT HEAD SCREW
(6 used in this step)
These edges
must be even.
Page 10
10S
N
Surface with holes
These edges
must be even.
B
433961
E
Surface with holes
www.sauder.com/service