Publicité
Table of Contents
Part Identification
Hardware Identification
Hardware Usage Guide
Assembly Steps
Français
Español
Safety
Warranty
!
WARNING
Use of a TV that is too heavy or large is hazardous. A TV that is too heavy will create a risk of a tip-over that can cause severe injury or
death. A TV that is too large for the available space might be accidentally pushed or bumped off the furniture, or subject to tip-over.
• Check the size and weight of your TV. Compare it to the diagram below – before you begin assembly!
• This Sauder unit is designed for use with flat panel televisions weighing less than 70 pounds. Never use with a TV that weighs more.
• The size of the television, front-to-back and side-to-side, must fit within the space defined in the diagram.
• Never place the front edge of the TV past the front edge of the TV support shelf (or stop molding – if equipped)
• Never allow the sides of the TV to extend past the side edges of the TV support surface.
• Be sure to apply the warning label as instructed later in assembly. The label provides important safety related information.
Page 2
Assembly Tools Required
3
4
6, 36
5-42
43-47
48-52
53-54
55
70-3/8"
70-3/8"
15-7/8"
15-7/8"
433961
No. 2 Phillips Screwdriver
Tip Shown Actual Size
Hammer
Not actual size
www.sauder.com/service
Publicité
