Publicité
Step 29
1
D22
P
Groove
å
Insert the DRAWER SIDES (D22 and D23) at an
angle into the slot at each end of the CENTER
DRAWER FRONT (P).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
å
Fasten the SMALL DRAWER BACK (D161) to the DRAWER SIDES (D22 and D23). Use
four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the SMALL DRAWER BOTTOM (D721) inserts into the groove of the
SMALL DRAWER BACK (D161).
www.sauder.com/service
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D23
D161
D22
D721
2
U n fi
n i s h
D22
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the SMALL DRAWER BOTTOM (D721) into the
grooves in the DRAWER SIDES (D22 and D23) and
CENTER DRAWER FRONT (P).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D23
433961
9
With the palm of
your hand, tap
the DRAWER
BOTTOM down
into the groove.
D721
e d
s u r
f a c
e
P
D23
30S
(4 used in this step)
Page 33
Publicité
