Publicité
Step 24
å
Fasten the remaining SHORT END MOLDING (E) to the RIGHT
END (A). Use two SILVER 1-1/8" FLAT HEAD SCREWS (10S).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
å
Fasten the remaining SIDE SKIRT (N) to the RIGHT END (A).
Use four SILVER 1-1/8" FLAT HEAD SCREWS (10S).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
These edges
must be even.
Page 28
SILVER 1-1/8" FLAT HEAD SCREW
(6 used in this step)
A
E
Surface with holes
These edges
must be even.
10S
433961
N
Surface with holes
www.sauder.com/service
Publicité
