Publicité
Step 28
å
Carefully turn your unit onto its front edges. Lay the BACK (BK1) over your unit as shown.
å
IMPORTANT: Your unit must be "squared up" to the BACK (BK1) before fastening. Make equal margins along the top and
bottom edges of the BACK (BK1). Then, make equal margins along the side edges of the BACK (BK1). Push on opposite
corners of your unit if needed to make it "square".
å
BACK INSTALLATION:
1.
Begin fastening the BACK (BK1) using four BLACK 9/16" EURO SCREWS (62S) through the four holes shown at positions 1.
2.
Finish fastening the BACK (BK1) to your unit using the NAILS (1N) through all remaining holes.
3.
NOTE: Be sure to tap NAILS into the holes that line up over the LARGE UPRIGHTS (G).
NAIL
(46 used in this step)
Page 32
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
1N
1
BLACK 9/16" EURO SCREW
(4 used in this step)
These holes must line up over
the LARGE UPRIGHTS (G).
1
BK1
1
433961
62S
1
www.sauder.com/service
8
Publicité
