Operation
7.9
Reset "R-Tronic" to factory settings
Proceed as follows to reset the "R-Tronic" to its factory setting:
1. Navigate to the main menu.
2. Select the SETTINGS menu option.
3. Select the FACTORY SETTINGS menu option.
4. Press the menu button. RESTORE appears on the display.
5. Press the menu button. Select the YES menu option.
6. Press the menu button to confirm your selection.
7. You have reset the wireless thermostat to its factory setting and can
reconfigure it.
7.10
Error messages
Error message
BATTERY EMPTY
REPLACE BATTERIES
POWER SUPPLY DEFECT
RADIO MODULE ERROR
INIT ERROR
MEMORY DEFECT
T-SENSOR DEFECT
H-SENSOR DEFECT
TIME PROFILE INVALID
Disconnect the power supply for at least 30 seconds and restart
the appliance to correct the errors. Insert new batteries if battery
operation is used.
36
Cause
The power supply for "R-Tronic" is
currently insufficient.
There is an initialisation error.
Error in the electronic memory.
Defective temperature sensor
Defective humidity sensor
Individual time profile incorrectly
programmed
R-Tronic
115078080-V01.10.2019