Télécharger Imprimer la page

SilverCrest HG09439C Instructions D'utilisation Et Consignes De Sécurité page 12

Publicité

and no button
,
3
automatically switch off.
Troubleshooting
= Fault
= Cause
= Solution
= The display shows one of the following symbols
when you switch on the product:
• "T"; or
• "-" symbol; or
• the numerical display
= The product has memory features of the previous
weight before switching off the product and
affects the calibration point during activation.
= 1. Remove any load from the weighing surface
if any.
2. Set the product on a solid, level and flat surface.
3. Reset the product by holding the button UNIT
for approx. 3 seconds.
4. The product is re-calibrated and the whole
LC display
2
5. The numerical display
with the default unit.
6. You can place the item you wish to weigh
onto the product.
=
= The product is overloaded.
= 1. Remove the overload.
2. Reset the product by holding the button
UNIT
for approx. 3 seconds.
4
12 GB/IE/NI
is pressed, the product will
4
showing any weight
8
will be shown for 2-3 seconds.
will read "0" again
8
3. The product is re-calibrated and the whole
LC display
4. The numerical display
with the default unit.
5. You can place the item you wish to weigh
onto the product.
Note: If
is shown again, it means the overload is
greater than the max. measuring range. Remove the
overload.
Note: Be sure never to add more than 5 kg to the
weighing surface
damage it.
,
1
=
= The batteries are too weak to weigh. You cannot
operate the product.
4
= Replace the battery (see section "Replacing the
batteries").
Note: The product contains sensitive electronic compo-
nents. For this reason it is possible that it can be disrupted
by radio transmitting equipment in the immediate vicinity.
If the LC display
objects away from it.
Electrostatic discharges can lead to malfunctions. In
cases of the product failing to work, remove the batteries
for a short while and then replace them.
Cleaning and care
Never immerse the product in water or other
liquids. This can damage the product.
will be shown for 2–3 seconds.
2
will read "0" again
8
. Overloading the product can
1
indicates a problem, move such
2

Publicité

loading

Ce manuel est également adapté pour:

460086 2401