Publicité
Note: Make sure you insert the batteries with the
correct polarity. This is indicated on the cover of
the battery compartment
Close the cover of the battery compartment
and tighten the screw
Operation
Set the product on a solid, level and flat surface
to weigh.
Weighing
Note: Always place the object you wish to weigh
gently onto the weighing surface
ing the glass surface.
To activate the product, you may directly put a
load (e.g. a bowl) with minimum 250 g onto the
weighing surface
surface
with a certain force is also a possible way
1
to activate the product. Press the button TARE
to reset the numerical display
Place the item you wish to weigh onto the weighing
surface
of the product. The numerical display
1
will show the weight of the item you are weighing.
Note: A slight touch of the button TARE
the button UNIT
4
product. If there is too much pressure, the product
may tilt. During this time the weighing equipment on
the product is adjusting. Afterwards the numerical
display
will read "0". The unit display
8
show the last unit selected.
Note: If an object (e.g. a bowl) is already on the
weighing surface
will show the weight of the object. You can always
press the button TARE
numerical display
.
5
.
6
to avoid damag-
1
. Pressing onto the weighing
1
to "0".
8
is sufficient to operate the
, the numerical display
1
at any time to reset the
3
to "0".
8
Place the item you wish to weigh onto the weigh-
ing surface
show the weight of the item you are weighing.
5
Incremental weighing
Touching the button TARE
will change the numerical display
ing to "0". The "Tare" symbol T
Now add another item to weigh onto the product.
The numerical display
the newly added item.
If you remove the item added to the product, the
numerical display
If you remove all items from the product, the LC dis-
play
2
the minus symbol
Then briefly touch the button TARE
"Tare" symbol T
Important! Be sure never to add more than
5 kg to the weighing surface
product can damage it.
3
Changing the measuring unit
8
and
To switch the unit of measure, briefly touch the button
3
UNIT
. After each time it is pressed, the unit display
4
will switch to the next unit listed:
will
7
Switching off
8
Holding the button TARE
will switch off the product. If no movement is detected
on the weighing surface
. The numerical display
1
with the product on
3
will show the weight of
8
will again read "0".
8
will show a negative value indicated by
.
9
will disappear.
10
1
g -> kg -> lb:oz -> oz
for approx. 3 seconds
3
for approx. 2 minutes
1
will
8
from the read-
8
will appear.
10
, and the
3
. Overloading the
7
GB/IE/NI
11
Publicité
