Publicité
Please read these notes:
* Maximum load capacity of dry clothes,
according to the model used (see control
panel).
**
Only available on certain models
INFORMATION FOR THE TEST
LABORATORIES
STANDARD PROGRAMMES
ACCORDING TO
(EU) No 1015/2010 e No 1061/2010
ECO 40-60
SETTING THE TEMPERATURE TO
40°C
ECO 40-60
SETTING THE TEMPERATURE TO
60°C
________________________________________
STANDARD PROGRAMME
ACCORDING TO
(EU) No 2019/2023
ECO 40-60
Before closing the cover and start the
washing process, please check that the
internal drum is perfectly closed. When
possible,
please
indicators with drum to assure the best
washing performance.
PROGRAMME
PROGRAMME
PROGRAMME
align
the
position
The spin speed may also be reduced, to
match any guidelines suggested on the
fabric label, or for very delicate fabrics
cancel the spin completely this option is
available with a spin speed button. This
function can be activated with the button
SPIN SELECTION. If the label does not
indicate specific information, it is possible to
use the maximum spin expected in the
program. An over dosing of detergent can
cause excessive foaming. If the appliance
detects the presence of excessive foam, it
may exclude the spinning phase or extend
the duration of the program and increase
water consumption.
( )
Only with PREWASH option
selected
PREWASH option available).
1)
When a programme is selected,
on the display is shown the
display shows the recommended
wash temperature that can be
reduced (where allowed) by the
relevant button.
2)
For the programmes shown you
can
adjust
intensity of the wash using the
STAIN LEVEL button.
PREWASH: if the dispenser has the
specific compartment for pre-wash, pour
the detergent in it. Otherwise, pour the
detergent in the perforated area present
on the drum, following the dosage
indications of the detergent producer.
IMPORTANT: do not use the pre-wash
mode with start-delay option.
77
(programmes
with
the
duration
and
Publicité
