Publicité
EN
In all correspondence and spare parts orders, please
always include the machine number specifi ed on the
type plate of the machine.
6.1 Repair and service workshops
can be found at the following link
https://de.wolff -tools.com/service/reparatur-service
6.2 Lubrication of the Impact fi g. B
The Turbo-Stripper EMK is virtually maintenance-free.
Have the guides of the swing bolts lubricated from time
to time (after approx. 500 square meters). The lubricator
nipples are located collateral on the front side.
The used grease will fl ush dirt out of the machine.
Press maximum 3 to 4 times with the grease gun. Never
press too much grease into the machine. Otherwise the
mechanism will be blocked.
Only use the original grease ( Art. No. 087733 ) "Lager-
meister WHS 2002.
Wear gloves and protective goggles when relubricating the
guide sleeves.
6.3 Changing the driving wheels fi g.C
Remove the splint-pins (4) and pull the wheels (3) from
the axle (1). Do not loose the keyes (2) under any circums-
tances!
6.4 Minimum size of the drive wheel
If the diameter is less than 164 mm, the rubber drive wheel
must be replaced.
6.5 Spare parts
Spare parts are available on the Internet:
http://webcatalog.wolff -tools.com can be found.
7.0 Trouble shooting
Fault
Possible cause
The machine
Power supply
does not start
interrupted
Defective cable
Defective plug
Higher exer-
Cutting blade
tion of force
dull
required while
working
20
8.0 Disposal information
Disposal
The machine, accessories and packaging
should be sorted for environmental-friendly recycling.
Only for EC countries:
Subject to change without notice
9.0 Notes on various fl oor
coverings
Operating instructions
► Do not place the power tool until a load that
causes it to stop.
The TURBO STRIPPER EMK is primarily used to remo-
ve linoleum, PVC, rubber, cork, design, and CV
coverings as well as needle-punched fl oor cover-
ing and carpeted fl ooring.
Hardwood parquet, multi-layer parquet, semifl exi-
ble and ceramic tiles can also be removed to a
limited extent.
► Needle-punched fl oor covering, carpet, PVC.....
The coverings to be removed should be pre-cut in
blade-widths (fi g. E) and then removed with the
stripper in one step. In many cases, the glue can
also be removed at the same time.
► Coverings without a foam backing:
Prior to performing the stripping work, pre-cut the
Remedy
strips in blade-widths (fi g. E). Regularly check
Contact
whether the blade is still straight and sharp.
Electrician
For repair and
► Coverings with a foam backing:
/or replace parts
Only use sharp blades! Remove the large sections
of the wearing surface. Use a carpet pulling claw for
Replace
this.
cutting blade
or resharpen
Then remove the foam residue with the stripper. If
there is some foam in the recess, approach from
the side.
Do not dispose of power tools into household
waste! According the European Guideline
2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally correct manner.
Publicité
