Description Of The Tool Indication; Remarks In Respect Of The Determined Use; Operation Of The Unit - Klauke mini + EK 15/50G-L Mode D'emploi

Instruction Manual Crimping Tool
EK 15/50-L / EK 15/50G-L

3.3 Description of the tool indication

See Tab. 1. Prior to operating the unit the charging level of the battery (pic. 1.5) should have been tested. A low char-
ging level can be detected by the fl ashing of the LED (pic. 1.3) for 20 s at the end of a crimping cycle.
4.

Remarks in respect of the determined use

Before starting any work on electrical appliances it must be safeguarded that there are no live parts in the immediate
assembly area of the user. If this not possible special precaution measures (
must be provided.
Keep your working area clean and tidy. Do not use this tool when you are tired, on drugs, had alcohol or if you are
medicated.

4.1 Operation of the unit

First you have to select the right dies for the intended application (see table 2). Cycle: see pictures in front.
Attention
Don't operate the tool without dies.
Attention
After having terminated the working cycle and prior to changing the dies remove battery to avoid unin-
tended use. Avoid unintended starts. Make sure the switch is in the off position before plugging in.
Attention
Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away from mo-
ving parts.
Attention
Keep proper footing and balance at all times.
Attention
Use safety gear and always wear eye protection.
Attention
The crimping process can be interrupted at any moment by releasing the trigger.
HE.14211_B © 07/2011
) for working near live parts
see EN 50110-1
4
GB