Publicité
b Tighten the union nut hand-tight.
2. Mix the detergent:
a Fill 1 cap (approx. 0.68 oz. / 20 ml)
of detergent into the spray bottle.
b Pour clean water slowly into the
spray bottle up to the MAX mark.
3. Assemble the spray bottle:
a Place the wiping attachment on
the spray bottle.
b Screw the spray bottle onto the
wiping attachment.
c Fit the microfiber wipe cover on
the wiping attachment.
Operation
Starting operation
Observe the following points to prevent
streaks appearing:
● Only glide the squeegee blade over
the surface to be cleaned, do not
press too hard.
● Hold the device at the correct angle
to the surface to be vacuumed. The
distance between the lower end of
the device and the surface should
be approx. 4 in. (10 cm)
8
● Use only a KÄRCHER detergent be-
cause this is specially developed for
use with the device.
● Spray a sufficient amount of deter-
gent on the surface so that the sur-
face is not too dry.
● Clean the squeegee blade regularly,
see Cleaning the squeegee blade
and suction nozzle.
● Replace the squeegee blade when
worn, see Cleaning the squeegee
blade and suction nozzle.
● Do not perform cleaning work under
direct sunlight or when the weather
is too hot.
1. Apply the detergent:
a Turn the spray nozzle to the "ON"
position.
b Press the spray lever and spray
the detergent evenly onto the sur-
face to be cleaned.
2. Loosen the dirt using the microfiber
wipe cover.
English
Publicité
