Publicité
3. Put the cap back on the waste water
tank.
4. Insert the waste water tank into the
device.
Cleaning the squeegee blade
and suction nozzle
1. Switch off the device.
2. Remove the suction nozzle.
a Press a screwdriver into the un-
locking opening of the suction
nozzle.
b Slowly pull the suction nozzle from
the separator.
3. Pull the squeegee blade sideways
out of the suction nozzle.
4. Clean the squeegee blade and suc-
tion nozzle under running water.
5. After drying, pull the squeegee
blade into the suction nozzle from
the side.
6. Push the suction nozzle into the de-
vice until it audibly latches into
place.
Cleaning the microfiber wipe
1. Remove the microfiber wipe cover.
2. Wash the microfiber wipe cover un-
der running water.
3. The microfiber wipe cover can be al-
ternatively cleaned in a washing ma-
chine at temperatures of up to 140
°F (60 °C).
Observe the following instructions on
caring for the device:
● Do not use fabric softeners.
● Do not bleach the microfiber wipe
cover.
● Do not dry the microfiber wipe cover
in a dryer.
● Do not iron the microfiber wipe cov-
er.
Troubleshooting guide
Malfunctions often have simple causes
that you can remedy yourself using the
following overview. When in doubt, or
in the case of malfunctions not men-
tioned here, please contact your autho-
rized Customer Service.
With increasing aging, the capacity of
the battery will decrease even with
good care, so that even when fully
charged, the full run time is no longer
achieved. This is not a defect.
The device does not work
The battery is not fully charged.
Charge the battery, see Battery
charging.
The device is defective.
English
cover
11
Publicité
