Publicité
Problem
The unit is running on a poor
quality power source like a low
quality generator. This power may
damage the tool.
Type A (Type 41) guards are intended for use with Type 41 (1A) cutting wheels and Type 42 (27A) wheels marked for cutting only.
Grinding with wheels other than Type 27 and Type 29 require different accessory guards. Always use the smallest proper guard
possible that does not contact the accessory.
nOTE: Type A (cut‑off) and Type B (grinding) wheel guards where previously referred to as Type 1/41 and Type 27 wheel guards.
When using segmented diamond wheels, use only
diamond wheels with a peripheral gap not greater than
10 mm and negative rake angle.
DO NOT USE
segmented diamond wheels with a peripheral gap greater
than 10 mm and/or a positive rake angle.
For all grinding, sanding, and wheel type wire brushing
accessories, the lowest portion of the accessory must
be contained within the guard enclosure with 2 mm or
greater clearance to the bottom lip of guard.
Problem Power Line
Solution
Try another power source, reduce
extension cord length or reduce
equipment used on the power source
at one time.
Type B
(shallow, Grinding)
additional Information for Guards and accessories
Guard Types
(closed cut off)
≤10 mm
Type a
EnGLIsh
≥2 mm
49
Publicité
