Publicité
EnGLIsh
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool
and the accessories, keep the hands warm, organisation
of work patterns.
CAUTION: Working with the wire brush or the abrasive
cutting can lead to different vibration levels!
WARNING : Grinding thin sheets of metal or other easily
vibrating structures with a large surface can result in a
total noise emission much higher (up to 15 dB) than the
declared noise emission values. Such workpieces should
as far as possible be prevented from emitting sound by
suitable measures such as the application of heavy flexible
damping mats. The increased noise emission is also to be
considered for both the risk assessment of noise exposure
and selecting adequate hearing protection.
EC‑Declaration of Conformity
Machinery Directive
Small Angle Grinders
DWE4347, DWE4357, DWE4369
D
WALT declares that these products described under
e
Technical Data are in compliance with:
2006/42/EC, EN62841‑1:2015+A11:2022, EN62841‑2‑3:2021
+A11:2021.
These products also comply with Directive 2014/30/EU and
2011/65/EU. For more information, please contact D
the following address or refer to the back of the manual.
The undersigned is responsible for compilation of the technical
file and makes this declaration on behalf of D
Vice President of Engineering, PTE‑Europe
Director Engineering
D
WALT, Richard‑Klinger‑Straße 11,
e
65510, Idstein, Germany
25.10.2023
DECLARATION OF CONFORMITY
MACHINERY AND RADIO EQUIPMENT
REGULATIONS
Small Angle Grinders
DWE4347, DWE4357, DWE4369
D
WALT declares that these products described under
e
"technical data" are in compliance with:
EN62841‑1:2015+A11:2022, EN62841‑2‑3:2021 +A11:2021.
These products conform to the following UK Regulations
38
The Supply of Machinery (Safety) Regulations, 2008, S.I.
2008/1597 (as amended).
The Radio Equipment Regulations 2017, S.I. 2017/1206
(as amended)
The Restriction of the Use of Certain Hazardous Substances
in Electrical and Electronic Equipment Regulations 2012, S.I.
2012/3032 (as amended).
For more information, please contact D
address or refer to the back of the manual.
The undersigned is responsible for compilation of the technical
file and makes this declaration on behalf of D
Karl Evans
Vice President Professional Power Tools EANZ GTS
270 Bath Road, Slough
SL1 4DX
England
25.10.2023
Definitions: Safety Guidelines
The definitions below describe the level of severity for each
signal word. Please read the manual and pay attention to
WALT at
e
these symbols.
WALT.
e
General Power Tool Safety Warnings
SAVE ALL WARNINGS AND INSTRUCTIONS
WARNING: To reduce the risk of injury, read the
instruction manual.
DANGER: Indicates an imminently hazardous
situation which, if not avoided, will result in death or
serious injury.
WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in death or
serious injury.
CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or
moderate injury.
NOTICE: Indicates a practice not related to
personal injury which, if not avoided, may result in
property damage.
Denotes risk of electric shock.
Denotes risk of fire.
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
FOR FUTURE REFERENCE.
WALT at the following
e
WALT.
e
Publicité
