Publicité
ELECTRICAL CONNECTION
NOTE: Follow the QR code on the following page to the Remote Power Supply Instructions [209-1470] to locate and install the
Electrical Enclosure in a remote location, and skip steps 1 & 2.
1. Using the diagram and chart on page 4, create a properly sized Electrical Enclosure rough opening. Reinforce the areas above
and below the rough opening with structural blocking. Hold the Enclosure up to the rough opening and mark the mounting hole
locations. Drill a 1/8" (3 mm) pilot hole at each marked location.
2. Feed the field wire through the AC Strain Relief. Feed the provided DC Cable [219-1803] through the DC grommet, making sure to
leave the DC Connector on the exterior of the wall. Insert the electrical enclosure into the rough opening.
1
Field Wire
1/8"
(3 mm)
© 2024 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
2
Field Wire
219-1803
7
DC Cable Connector
Part no. 209-1471 09/16/2024
Instinct Mirror Installation
Publicité
