Publicité
Never stand up with your feet
inside the product.
m WARNING! Do not use
this product and consult your
doctors if you suffer from any of
the following conditions:
–Skin inflammations
–Wounds/swelling of the feet
–Skin reddening
–Diabetes
–Eczema/psoriasis
–Heart disease
m CAUTION! The product's
surface becomes hot during
operation. Persons insensitive to
heat must be careful when using
the product.
m ATTENTION! Risk of
product damage! Do not
add any additives, like oil, to the
water container. After the water
has evaporated, these additives
may burn and damage the
product.
Fire/burn hazard and heat
m DANGER! Risk of fire!
Never leave the product
unattended while it is plugged
in.
Never select the keep warm
function if there is no water
inside the water container.
18 GB/IE
˜ Before first use
1. Take the product out of the packaging and
remove all packaging materials and plastic
wrappings.
2. Check to make sure that all listed parts are
included (see "Scope of delivery").
3. Check whether the product and all parts are
in good condition, if any damage or defect is
detected, do not use the product, but follow the
procedure described in chapter "Warranty".
4. Before first use, clean all parts of the product
as described in the chapter "Cleaning and
care".
˜ Preparation
m
ATTENTION! Risk of product damage!
Do not fill in water at a temperature exceeding
42 ºC. Always check the water temperature
before placing your feet inside or switching on
the product.
Do not fill water above the MAX marking
Do not splash water on the function button
the ON/OFF indication light
of the product.
Do not remove the massage rollers
splash guard
, except when cleaning the
[
2 ]
product (see "Cleaning and care").
NOTES:
Only use clean water. Do not add any soap,
o
bath salts or any other substances to the water
container
.
8 ]
[
Do not operate the product without having
o
filled in water first.
Before and after each use: Clean the product
o
(see "Cleaning and care").
1. Fill the water container
with water in the desired temperature.
2. Place the product on an even, stable,
heat-resistant, clean, non-slippery and dry
floor.
3. Connect the supply cord with power plug
to a suitable socket outlet.
.
9 ]
[
,
1 ]
[
or the base
[
]
or
[
]
up to MAX
8 ]
[
[
9 ]
[
]
Publicité
