DeVilbiss Healthcare drive PulmO2 Guide D'utilisation page 6

1.1 INTRODUCTION
This instruction guide will acquaint you with device. Make sure that you read and understand this guide before operating your
unit. Important safeguards are indicated throughout this guide. Pay special attention to all safety information. Contact your
equipment provider should you have any questions.
1.2 Intended Use
The PulmO2 10 Liter oxygen concentrator is intended to provide supplemental oxygen to patients requiring oxygen therapy.
1.3 Contraindications
None known.
1.4 Indications For Use
The PulmO2 10 Liter oxygen concentrator is intended to provide supplemental oxygen to patients requiring oxygen therapy. The
device may be used in the home or a clinical setting. The device is not intended to be life sustaining or life supporting.
1.5 Essential Performance
The essential performance of this device is to deliver a continuous flow of oxygen. Visual and audible alarms are provided if the
flow of the of the concentrator is lost or degraded.
1.6 About Your Device
Oxygen concentrators are the most reliable, efficient and convenient sources of supplemental oxygen available today. The
oxygen concentrator is electrically operated. The unit separates oxygen from room air which allows high-purity supplemental
oxygen to be delivered to you through the oxygen outlet. Although the concentrator filters the oxygen in a room, it will not affect
the normal amount of oxygen in your room.
NOTE
‣ Drive DeVilbiss recommends for optimal service life that the PulmO2 10 Liter Oxygen Concentrator be operated
for at least 30 minutes after it is powered on. Shorter periods of operation, operating in extreme temperature
humidity conditions or in the presence of contaminates, and/or handling and storage conditions outside those
specified, may affect the long term reliable operation of the product.
DRIVE DEVILBISS (OSD)
The OSD (Oxygen Sensing Device) is a device within your concentrator that monitors the oxygen produced by your unit.
The OSD lights on the top panel are defined as follows:
‣ Green Good Oxygen LED – acceptable oxygen level.
‣ Yellow Low Oxygen LED – below the good oxygen level.
‣ Red Critical Low Oxygen LED - below the critical oxygen level.
If the oxygen purity falls below the acceptable level: The green Good Oxygen LED will shut off, the yellow Low Oxygen LED will
light up, and an intermittent audible signal will sound. If the oxygen purity continues to fall into the critical low level, the Red
Critical Low Oxygen LED alerts with an audible alarm.
Refer to the Troubleshooting (Section 4) in this guide. Do not attempt any other maintenance. Contact your service technician or
service department immediately for assistance if the issue is not resolved.
IMPORTANT
‣ It is recommended that the clinical staff or provider lock the flow control knob to prevent inadvertent adjustment. A
flow setting other than prescribed may affect the patient therapy.
‣ Do not service or clean this device while in use with a User.
‣ The 1060AW Series oxygen concentrator, its parts and accessories are specified for use at flow rates between 1
LPM and 10 LPM.
‣ When used in a homecare environment, the patient is the intended operator.
EN - 6
OXYGEN SENSING DEVICE
®
SE-1060AW