DeVilbiss Healthcare drive PulmO2 Guide D'utilisation page 11

2. OPERATING INSTRUCTIONS
HOW TO SET UP THE DEVICE
1. With the power switch (Figure A) of the device in the OFF position, insert the power cord (Figure B) into the
IEC Connector located on the backside of the device. Insert the other end of the power cord into the wall
outlet as shown below. (Figure C)
2. With a clean cloth wipe away any dust that may be on the cabinet air filter (Figure D) and filter door
vents (Figure E), which are located on the back of the device, as shown below.
3. Connect oxygen tubing to the oxygen outlet by
either installing a humidifier bottle or attaching the
tubing directly.
3.1 Humidifier:
a. Fill the humidifier bottle as per
manufacturer's instructions.
b. Tightly screw the wing nut located
on the top of the humidifier
bottle to the oxygen outlet so that
the humidifier bottle hangs from
the oxygen outlet, as shown.
(Figure F)
c. Attach the oxygen tubing directly
to the humidifier bottle outlet
fitting, as shown. (Figure G)
3.2 No Humidifier:
a. Attach Oxygen Outlet Connector
to the oxygen outlet
b. Attach the Oxygen Tubing to the
Outlet Connector. (Figure H)
SE-1060AW
Scan for video Instructions
EN - 11