Dmx Controller - BoomToneDJ LUDIBEAM RGBW Mode D'emploi

To select the
the ENTER button and all channels of the unit will return to their standard position.
5. How to control the fixture
You can operate the unit in two ways:
1. By master/slave built‐in preprogram function
2. By DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be affected at once. Each time you turn the unit on, it will show
display. After that the unit will be ready to receive DMX signal or run the built in programs.
4.1 Master/Slave Build in Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to
give an automatic, sound activated, synchronized light show. This function is good when you
want an instant show. You have to set the first unit in master mode
(Random show),
input jack will have nothing plugged into it, and its master LED will be constantly on and
sound LED will flash to the music. The other units will have to select
or (2 light show) mode, Their DMX cables plugged into the DMX input jacks (daisy
chain) and the slave LED lights will be constantly on.

4.2 DMX Controller

Using a universal DMX controller to control the units, you have to set DMX address from 1 to
512 channel so that the units can receive DMX signal.
Press the MENU button up to when the
button and the display will blink. Use UP and DOW N button to change the DMX512 address.
Once the address has been selected, press and keep ENTER button pressed up to when
the display stops blinking or storing automatically 7 seconds later. To go back to the
, press the ENTER button to show the RESET on the display. Press
(Show 1) or ... Or
(Show 12) mode. Its DMX
is showing on the display. Press ENTER
22
on the
and select
(normal)