Side ejector (Fig. 9)
You must fi t the mulching adaptor (20) in order
to use the side ejector. Hook in the side ejector
adapter (21) as shown in Fig. 9.
5.1 Charging the Lithium-Ion battery
The corresponding instructions can be found
in the original operating instructions for your
charger.
5.2 Battery capacity indicator
(Fig. 19)
Press the battery capacity indicator switch (28).
The battery capacity indicator (27) shows the
charge status of the battery using 3 LEDs.
The charge level can also be read from the
indicator (Fig. 10 / Item 24) on the upper long
handle. The indicator does not work in the case of
batteries with switching function (e.g. 4-6 Ah).
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The temperature of the battery is too low. Remove
the battery from the device and leave it at room
temperature for a day. If the error occurs again,
this means that the battery has been completely
depthdischarged and is defective. Remove the
battery from the device. Never use or charge a
defective battery.
Fitting the battery (Fig. 14,15)
Open the battery covering hood (Item 4). Then
insert the batteries in the mounts as shown.
For optimum mowing results and battery power
performance it is always best to use batteries with
the same capacity.
It is also possible to use batteries with diff erent
capacities in the battery mounts A and B (Fig. 14).
Always make sure, however, that you use only
batteries of the same capacity in each separate
battery bank (Fig. 18).
For example, you could use two 4.0 Ah batteries
in one battery bank while using two 5.2 Ah
batteries in the opposite battery bank.
Anl_GP_CM_36_52_S_Li_BL_SPK7_NA.indb 15
Anl_GP_CM_36_52_S_Li_BL_SPK7_NA.indb 15
EN
Important!
Use only batteries which are charged to the
same level. Never combine full and half-full
batteries. Always charge the two/all batteries
simultaneously.
The equipment's operating time depends on the
battery with the lower charge level. The two/all
batteries must always be fully charged before use.
Close the battery cover by swinging it down, and
make sure that it latches in place correctly.
6. Operation
Caution!
The lawn mower is equipped with a safety switch
to prevent unauthorized use. Directly before
starting up the lawn mower insert the safety plug
(Fig. 11) and remove the safety plug again when
interrupting or terminating your work.
Important!
For safety reasons, it is not possible to start the
cordless lawn mower if the pitch angle is over
~70° ± 10°.
Caution!
To prevent the equipment switching on
accidentally, the lawn mower is equipped with
a safety switch (Fig. 10/Item 8) which must be
pressed before the switching bar (Fig. 10/Item 1)
can be activated. The lawn mower switches itself
off when the switching bar is released. The start
time can amount to several seconds (To make it
easier to start, tilt the lawn mower slightly at the
back (Fig. 17)). Repeat this process several times
so that you are sure that the machine functions
properly. Before you perform any repair or
maintenance work on the equipment, ensure that
the blade is not rotating, that the safety plug (16)
is disconnected and that the batteries (25) have
been removed.
Warning! Never open the chute fl ap when the
collection bag has been detached (to be emptied)
and the engine is still running. A rotating blade
can cause serious injuries!
Always carefully fasten the chute fl ap and
collection bag. Before you remove them, fi rst,
switch off the motor and pull out the safety plug
(16).
- 15 -
23.07.2024 08:59:52
23.07.2024 08:59:52